What is the minimum insulation value required for a cable
between phase to phase and phase to earth of 380 Vac 50Hz
circuit, having load arround 800 amps.
Answer Posted / md ashhar
0.5 Megha ohn
Is This Answer Correct ? | 11 Yes | 2 No |
Post New Answer View All Answers
why the starting voltage drop in a cable needs to be limited?what is percentage of the voltage drop allowed during starting?
Why do power lines not short out when they fall into water?
Hi I'm doing my MBA(3rd semester).I applied for the post of ET conducted by BHEL the last year.I cleared the written and lost in personal interview.Again I wrote the exam this time and cleared the written n yet to take the personal interview.Shall I disclose in the interview about my studies.What shall i say if they ask about my change from studies to job
if grounding is notdone at regular intervals for long distance transmission, will the load connected at distribution end receive voltage during negativehalf cycle of the sine wave?
Explain how you intend to work under pressure to meet up with deadline target?
How is the resonant peak, resonant frequency, and bandwidth determined from nichols chart?
State the methods of improving power factor?
What are :- AC Distribution Board (Single & Double Front) DC Distribution Boards Distribution Board LT Breaker Panel.
for a 500 KVA connected load, I calculated 30% of capactor for power correction. Even after using 225 KVR capactor PF is not improving. What could be reason for low Phase correction factor?
how to decide the panel size like MDB ,SMDB PANEL SIZES
is there any chart showing the suitable cable size according to AMP and length ? for three phase motors
How will polarity test of Dy5 Transformer ?
how open delta PT works & what is its construction?
Can we put 3 layers of cable tray while installing tray
How to calculate cable size in HT AND LT