Interested to Buy Any Domain ? << Click Here >> for more details...
Dear All
can any one told me that VFD Make ABB Model ACS800-01 used for dual Source like
1.DC Source applied at terminal UDC+,UDC-
2. 3 phase 400AC,50Hz
- 1 Answers
- 2524 Views
- I also Faced
- E-Mail Answers
Answer Posted / alf
Poorly worded question.
1) The VSD (Inverter) is connected to an external supply at 400V, 3ph, 50Hz..
2) UDC+, UDC- (R+; R-) are the terminals for connecting an external brake. The voltage on these terminals is over 500Vdc and is supplied FROM the VSD, not connetected TO the VSD
| Is This Answer Correct ? | 0 Yes | 0 No |
Post New Answer View All Answers
please tel me the calibration of pneumatic controler.
Explain PID, ON/OFF, Controls
how to calibrate mass flow meter (Coriolis)? Example calibration range: 0 to 2500 kg/hr line size 3" fluid: Etheline glycol (MEG)
What is the purpose of LO Overhead tank in turbines.
What is difference of fanuc alpha series 16i and 18i controller.also what is differnce betn TC and MC controller
How to find out the current of two motors having same power consumption but different RPM?
i want to find out iffco get test paper
What is loop1 and loop2 in MTS LT?
what is the field bus calble ? what are diffrences in orang colur cable and black coular calble ?
IS there any effect of vortex in low pressure side of the transmiter after the orific in feed water line? if yes then what is the calculation?
how can use ram
what step is taken for ESD ( emergency shut down) in DCS REPLY to hashimka20009@gmail.com
What is zener diode? What is voltage regulator?
Linear amplifier.
how can be calibrate flow indication transmitter (rosemount) it shows excess milli amps nearly about 24 ma on full scale, but its scale was set on 20ma on full scale..???how can be simiulate..???
