Interested to Buy Any Domain ? << Click Here >> for more details...
two bolbs of 100w and 40w respectively connected in series
across a 230v supply.which bolb will glow bright and why?
- 16 Answers
- 62810 Views
- DRDO, PSPCL, Siemens, I also Faced
- E-Mail Answers
Answer Posted / dinesh dafare
40 w bulb is high resistance approximately 1322 ohms and
100 e bulb is low resistance approximately 529 ohms .
Hence in series circuit voltage divide and current same.
Hence current required to 40 w is less than 100w so 40 w bulb is brighter
| Is This Answer Correct ? | 1 Yes | 1 No |
Post New Answer View All Answers
8. A DYNAMOMETER TYPE WATTMETER RESPONDS TO THE.......
what are the different sizes of U.G. cable & where these cabl;es are used according to voltage ..
WHY TERTIARY OF POWER TRANSFORMERS IS LOADED WITH EQUIPMENTS LIKE CT,PT,ISOLATOR AND CB
How to decide the size of the capacitor for a single phase induction motor say 2 HP ??
where can the transformer having vector group Yny0 be used??
What is sink and source?
How much earthing frequency is capable?
how will reduce the voltage. if 12volt/250ma transformer toreduce 6 volt
What is the Designing & Selection Procedure for a DG/Transormer of rated capacity?
1.What is the range of stator resistance of 3-phase induction motor? 2.Two electrically operated vibro motors are foxed in parallel direction in vibrating feeders. what is the direction of both vibro motors?
What is pi controller?
can I improve the furnace power factor (10 mva transformer) by adding a capacitor bank before the transformer.Does system power factor vary a lot with the furnace PF?
please give me all the Alarm .Trip ,Safety Relays & Conditions of Chiller mail me on ashokbabunhce@gmail.com
The screw thread commonly used for transmission of motion is one of the following types of threads
Scott connection is used for A 3-phase to 2-phase conversion B to achieve higher effciency C to save copper D to reduce harmonics
