How to calculate productivity of construction equipment
like excavator, dozer, rock breaker, riper
- 7 Answers
- 93215 Views
- I also Faced
- E-Mail Answers
Answer Posted / mickey
There is a program can calculate that based on type of soil, distance to dump site etc. MechaNorm by Giant Robot Systems
| Is This Answer Correct ? | 2 Yes | 1 No |
Post New Answer View All Answers
percentage of metal,clay or soil & water in water bond macadam roads to know the quantities for each in total volume of 11500 cubic meters
what is shuttering co efficient?
For sloping slabs or sloping beams why the tension steel from either side of ridge is taken into compression zone of other side?
What is a hatch patterns?
Design a shear wall of length 4.20 m and thickness of 250mm subjected to the following forces.Assume Fck = 25Mpa and Fy = 415Mpa and the wall is a high wall with central part 3440mm x 250mm and two 380mm x 760mm strong bands at each end with following loading. S.No. Loading Axial force Moment Shear 1 DL+LL 1950 600 20 2 Seismic load 250 4800 700
how many spacers we need for 1 ton reinforcement? aprox.
How much Tolerance factors like 1. brick work 2.plaster 3.painting 4.floor tiling 5.wall tiling 6.shuttering 7.concreting 8.steel
20 mpa what is the quantity of cement sand and aggregate in one cubic meter of pcc non rainforcement concreate kindly answer including formaula thanks
How we can calculate the cement, sand,bricks , water , quintity in 1:6 Ratio 1 cubic metre b/w and 1:4 Ratio in 1 Squre metre b/w????
1.Why we are preferring 43 grade cement than 53 grade cement. 2. Approximate cost difference between 43 and 53 grade cement. Thanks.
I measured pcc work as 15.34 m cube , the ratio is 1:5:10 ,want to know the cement, sand and metal used for pcc measured as 15.34 m cube at this ratio.
how to calculate the mortar for 10'*10' size room for both plastering and for masonry work?
What will be weight of 0.5mm GI sheet per sq.ft?
WHAT GOAL DO YOU HAVE IN YOUR CARRIER?
I am practising engineer. I am searching for tutorial of RCC T Girder design Example in staad pro.Do anybody has this?please help
