What is the correct position of lapping splice of reinforcement steel bars in a beam at top & bottom of the beam?? what is the reason for this location?..what are the factors affecting lapping location in beam?
- 6 Answers
- 16537 Views
- SPCL, I also Faced
- E-Mail Answers
Answer Posted / jagga
The location of splice should be 30-50 cm above the floor level
| Is This Answer Correct ? | 1 Yes | 0 No |
Post New Answer View All Answers
What is chemical composion test
density of crush sand & crush stone or grit powder
What is type failure of road surface? how to repair the failure of road surface?
What in bending moment, if a moment is free end of cantilever beam?
Can someone please be curing period of the following according to IS codes Column beam slab brick masonry raft found. and also tell how many hours/day
What is the cemnent ratio
what is the sequence of the activities in the typical under ground water tank including civil & MEP works.
what are the proper pipes for salt water line
how to estimate material requirement for an area of house in square feet?
how to determine the correctness of proportion used in cement mortor and various IS codes to determine the same?
What is the strength of 1:6:12 mix?
what is total volume of ingredients used in concrete accordingly
what is the maximum number of course that can be laid according to IS code and the max height.
why we provide bent up reinforcement bars at l/4 ? if it is because of diagonal shear , how does it acts ?
within an emergency scenario what are the safe systems of work a coss can setup as part of is duties
