Sir,I have finished my B.E in the Stream of EEE.How Can I get
C license for Electrical???Please Tell me the way...My mail ID
is praba1003105@gmail.com Cell:7402474123
- 1 Answers
- 1901 Views
- I also Faced
- E-Mail Answers
Answer Posted / hari ramesh
To get a c license one must have completed be eee and have a minimum 2 years experience in ht equipments handling like transformer maintenance , ht cable laying, etc. To get that experience you need to work in electrical maintenance department in large plants ( any plant) like automobile manufacturing factory , foundry, etc. For example , tvs , wabco, hyundai etc . In chennai. After that you have to apply for license to govt. Then they will conduct an interview and if you pass you will get license. Of course vitamin "money" will be needed to speed up the process . Yet as it involves human life , interview and experience requirements cannot be bypassed using "m". To get the experience you have to work in those plants. To get work mostly reference is the best way for freshers
| Is This Answer Correct ? | 0 Yes | 0 No |
Post New Answer View All Answers
At what factor resistance r of a conductor depends?
wat is the current produced in a 5000v megger? when the positive and negetive terminals are touched on our body get s shock?
Draw a SLD of HT distribution EB grid up to users Transformer?
What is CVT and what is relation with wave trap?
Transmission through a short line depends on
How to calulate Locked rotor amper(LRA) for compressor type motors?
As we know diode work on both negative and positive but converting ac into DC we have to given a/c from negative of diode or positive side.please give me answer.
what is the difference b/w UHVDC and HVDC(LIGHT)?
What is the application of Dyn1 and Dyn11 vector group of transformer?
what is rating boiler
1 “earthing” for bonding of equipment and circuits to common plant earth electrode potential, 2 “protective earthing (PE)” when this bonding is required for personal safety provisions 3 “grounding” for interference suppressing bonding of screens, sys-tems with ground level 4. low-impedance earthing ? 5.primary earthing system and secondary earthing system what is that? 6.earthing electrode or mesh net earthing electrode ? very confusing , simple but very informative help required ? i will be very very thankful to you guys.
i want to know d working mechanism of tafe tractors next i like to know d engine type of apache bighs can anyone help me
For a 6.6kV Motor it is recommended to do megger test with 500 V d.c and not more than 5kV d.c but the Hi voltage withstand test should be performed by 12kV AC. Why the dc voltage test should be limited but AC voltage withstand test could be with such a high voltage?
How does PLC work for sychronising of Two or more DG sets?
What is step signal?
