Interested to Buy Any Domain ? << Click Here >> for more details...
Where do we consider the pressure in mbar & where do we consider the pressure in bar & why is it so ?
- 2 Answers
- 3575 Views
- BOC, Jindal Steel and Power, I also Faced
- E-Mail Answers
Answer Posted / samir
mBar and Bar are both pressure unit. As per our system pressure we used the desired unit range transmitter or switches. As example if we have to measure PA fan header pressure pressure it's range very low as 5-10 Kpa,eg; 50-100mabar. So here we can used a transmitter or switches in bar unit instead Bar.
| Is This Answer Correct ? | 0 Yes | 0 No |
Post New Answer View All Answers
A DP transmitter is used to measure the level of an open tank. The drain line of the tank is connected to a control valve, and is configured as, if the level of the tank is 90% the valve should get open 10%. And if the tank level is 10%, the valve should get open 90%. Draw wiring diagram and explain how to configure DP transmitter and control valve using HART communicator. If the span error at output is 1%, what will be the %opening of the control valve at 60% level of the tank?
What is limitation of the ht.of the displacer of a level trol?
please can any one tell me clearly about pid tuning i am confusing about this .how to tune pid easly?
What is stripper & spilitter ? Diffrence in this.?
What is Droop? What is Step/Gradient Limiter in Turbine Governor control?
Why ac supply load cell is used? Can we use the dc supply load cell?
How will you calibrate an Absolute Pr.Transmitter of range 400mmHg absolute ?
Why mmwc unit is used?
To become an Instrument DESIGN engineer, is there any softwares or training to become Instrument Design engineer, plz suggest me, Iam very much interested in designing.
What is heating effect?
1.can you use SCADA instead of DCS,DCS instead SCADA 2.Difference between DCS and PLC,can their role be reversed i.e. role interchange 3.Difference between RTU and PLC
Where Can i take a SPI INtools training in Mumbai? In Rolta India Ltd to whom I should approach regarding of SPI INtools Training?
What are the uses of orifice plates?
dear friends, i have seen flow as the selection critriea in presure guage (bourdon tube) and i would like to know what is the relation between flow and performance of pressure guage other parameters i found in the data sheet are pressure max. 1ksc temperature max. - 50 deg c line size - 80NB operating range - 1ksc pr. guage range - 0-2 ksc thank u,
What is the minimum rating availalbe for weld neck orifice in market?
