Interested to Buy Any Domain ? << Click Here >> for more details...
what is the difference between HV and LV Breakers?
- 4 Answers
- 12735 Views
- GM General Motors, OEG, I also Faced
- E-Mail Answers
Answer Posted / kannan
* hv (11kv, 3.3kv)breakers mostly used for sf6 or vaccum because breaker inside of conduct points are very near.
* incase use the normal ACB at HT side, induction voltage came so affect the isolation and total system.
| Is This Answer Correct ? | 0 Yes | 0 No |
Post New Answer View All Answers
what is maxemo work permit procedure
3- What is the target from Zero Impedance, Single Phase Imp., S/C Imp. and magnetic balance tests?
pre arcing time of ehv breaker
what is the prosses for getting of 33kv licence (i have completed my engineering degree & working in 33kv substation for contract basis )????
What is the difference between voltages or potential difference? And what are they?
i ha done my 10th with 71% ,ITI with 81% 11th with 75% 12th 43% apprentiship with 71% in SAT i secure 1390 ,TOEFL 27 i was refused four times and in all me interview visa officar told that i am not Qualify for study in USA but i completed my 12th yes i got low persentage in my 12th but i seen to much student they already got visa with them 3 or 4 backlocs so why they are refused me ?
What is meant by a stray loss of a induction motor??? What is the equation to find it
We have a couple of oil tanks at our plant. One of them does not have a lightning arrester installed. My question is it necessary to install an arrestor on every tank or will this particular one be covered by the arrestor installed on the ajdacent tank, Since all the tanks are close to each other. Basically, I want to know that if these arrestors or protection works in a parituclar area of effect or influence. Thanks
An 8 pole, 50 Hz, 3-phase IM is loaded to a poing where pull out torque will occur. The rotor resistance per phase is 0.3 ohm and motor stalls at 650 rpm. The rotor reactance at stand still is A 2 ohm B 1.25 ohm C 3.15 ohm D 2.25 ohm
In ups static switch if i gives the supply at output end it will open the circuit in stactic switch or not if it will open then how it operates.
what happens in the short circuited secondary transformer,if the resistance of the short circuit is increased gradually?
bitumar
what is metering cum synchronizing panel and how it is used?
Why do we perform an open-circuit test and short-circuit test on the transformer?
full form of flry b
