What do you mean by S.F.U. unit? application of it.
Answer Posted / sajin
It consist of an isolator and a fuse. When a fault comes the fuse will break. The switch can be used for replacing it. For any maintanance in the electrical installations we can use the switch for isolating the supply
| Is This Answer Correct ? | 0 Yes | 1 No |
Post New Answer View All Answers
How to use earthing on shipments.
What is meant by load angle of an alternator? Upon what factors does the load angle depend?
At full load wat is the motor p.f And at no load will is the motor p.f?
Apparent power is expressed as V * I(Conjugate). Why not in V * I ?
What conditions are required for transformer to operate at low frequencies ?
How can we select suitable capacity generator for three phase load (inductive load) and how to take study analysis in 3 three phase load system ?
How is the gain affected by the introduction of feedback in a control system.
Why are short circuit ratings always 16kA,25kA,36kA and 50kA.Who has fixed these?
what is the interrelation between voltage current torgue speed and magnetic flux in case of different types of electric motors
what is meant by re-rolling motor? how it differs from standard motor?
3Cx240 & 3Cx300 sqmm Al. cable from lv side. What is the calculation for this cable??
if the motor rated speed is 950rpm. how to change the above rated speed? is it possible?
new 90kw motor installed so how I purchased cable ,fuse,etc please give me technic for cable selected why always capacitor delta connection
what is a vector protection in transformer
What should be the height of basement according to NBCC code?