Interested to Buy Any Domain ? << Click Here >> for more details...
What is Difference between Bench Set & Operating Range of
Control Valve?
- 1 Answers
- 5968 Views
- AB Sugar, I also Faced
- E-Mail Answers
Answer Posted / praveen kumar
bench set is called based on the line pressure, control valve actuator spring adjustment....if control valve spring range 0.4-1.0 bar means ..the control valve will start to opened at 0.4bar instrument air pressure.before or after 0.4bar it should not start to open, at 1.0 bar the valve should be fully open(max travelling range of valve)...
Operating range is called as positioner output 0.2 to 1.0 bar...
| Is This Answer Correct ? | 1 Yes | 0 No |
Post New Answer View All Answers
it is possible to check the fail safe condition in pressure transmitter. if possible how?
Where are oxygen analysers installed in cfbc boilers? What are their usual readings?
Why all the drains(Gland sealing,ESV,Casing inlet etc) are directly connected to the flash tank instead of hotwell of the condensor in the power plant? My Email Id:naba02222@gmail.com
How does temperature bath work? How does coil gets heated only by applying some current?
what is output of FOUNDATION FIELD BUS transmitter
How to Calibrate Flow Switch in field
i need some objective type questions in instrumentation
Explain why plc require in analog input 4-20amp & 0-10 volt?
all types instrumentation questions want
why I need valve guard and whats different between guard and positioner ??
What are primary elements of measuring pressure?
What is compensation for flow ? Why we use compensation ? What are the factors of different compensation ? We not use then what problems may happen ?
what is the difference between magnetic flow meter and mass flowmeter
Why 4-20 amps is being used in instruments? Why cant we use any other range instead of 4-20 amps? Why only 4 amps is taken as lower limit and why 20 amps is taken as the higher limit?
Which is the best field foundation bus. ( FF ) Yokogawa, Honeywell or others ?
