Interested to Buy Any Domain ? << Click Here >> for more details...
I am working in a process industry, in that there are
several sections devided in the SCADA screens and
individual sections may START independently. But sometimes
i am facing problem i.e, if section 2 Stopped by the
operator immediately Section 1 or Section 3 or Section 4 is
getting stopped can you expain the reason behind this?
- 5 Answers
- 6168 Views
- I also Faced
- E-Mail Answers
Answer Posted / jitendra chauhan
following problem may:
1. Is same interlock may used other sections?
2. have you checked stop command DO of all section, may that same DO?
3. may network getting stop, may PLC going to stop while given to stop command?
4. may that same stop command linked on SCADA?
| Is This Answer Correct ? | 0 Yes | 0 No |
Post New Answer View All Answers
Explain the difference between plc and cnc?
what is the difference between profibus and controlnet networking.
Explain why plc require in analog input 4-20amp & 0-10 volt?
CONTROL VALVE OPERATING IN MANUAL BUT NOT IN MANUAL. WHAT SHOULD BE THE PROBLEM ?
What is motion balance principle?
What is the exact differences between HART,FOUNDATION FIELDBUS,PROFIBUS?
why we r opening HOT BYPASS valve during startup of a compressor?
POSSITIVE PULSE IS APPLIED TO AN INVERTER INPUT.THE TIME FROM THE LEADING EDGE OF THE INPUT TO THE LEADING EDGE OF THE OUTPUT IS 10 ns. THE TIME FROM THE TRAILING EDGE OF THE INPUT TO THE TRYLING EDGE OF THE OUTPUT IS 8 ns. WHAT ARE THE VALUES OF tPLH and tPHL?
Speedtronic system .
What is the difference between PLC and DDC?
How would you choose differential range?
explain key exchanges in all security modes WPA,WPA2,TLS?
If fire would be inside the plant which fire detector is to detected the fire.
What is difference between differential pressure & delta pressure?
How we can check the 2 wire proxy switch? & how it is connected to DI MODULE OF PLC?
