Why voltage regulation of an alternator is negative for a leading power factor?
Answer Posted / arijeet chakraborty
In case of leading load that means capacitive load, the effect of armature flux on main field flux is magnetising i.e, the armature flux is adding up with the main field flux. Since it is adding up, the total induced emf(V) will also be more than the induced emf at no load(E).
Therefore voltage regulation= -ve
Is This Answer Correct ? | 56 Yes | 1 No |
Post New Answer View All Answers
how to avoid electrical shock how capacitor store charges wat are the speed control of induction motors state faradays law flemings left hand rule what is rotary converter wat is transmission and distribution what are the sources of energy abrevation of acb,vcb,sf6,igbt what is output equation of transformer which test copper iron and iron loss are calculated what is eddy current draw a single line diagram (10 marks) draw direct online starter(10 marks)
We normally make oil soak pits under Transformers. Oil from soak pit goes to collection pit. We provide granules/pebbles under transformers. My question is weather granules/ pebbles to be filled in soak pit or not? if yes upto what level?
Hoe do calculate the Cable size for Amps rating ?
Explain cmrr?
is it necessary to earth the rmu before cutting off the transformer winding?if yes why?
why it is so called as xlpe(cross linked poly ethyline) cable?
1.what is difference in maintain Hz again Hz in USA ? 2.how to calculate the battery AH? 3.why are yearly maintained in transformer how many tests in required?
please describe the Transformer setting, Motor setting, I/C setting, Tie setting
how does an centrifugal and screw type chiller will work. which chiller efficiency is high and why.
11kv/433v delta/star distribution transformer primary side full load Ht current is 83.33A in , but input side VCB rating 800A.why?
write circuit diagram for a motor rotate in forward direction once it started and when pressed the same button it should rotate in anticlockwise.
what is the maximum temperature rating of a thhn insulated conductor?
why ss stablity limit is more transient stablity limit?
If there is major % of Voltage harmonics in the system, how can it be control or reduced?
How does a transformer contribute towards the widespread popularity of ac system over dc?