Interested to Buy Any Domain ? << Click Here >> for more details...
What is the reason for low voltage in houses?
- 19 Answers
- 54906 Views
- Maytas, I also Faced
- E-Mail Answers
Answer Posted / thomas aquinas nzo
If one of phases is feeding on the other this can lead to those at far end receiving low voltage and if care is not taking you end up burning the winding
| Is This Answer Correct ? | 0 Yes | 0 No |
Post New Answer View All Answers
If a current -8+6sin6t is flowing three ammeter, one is a centre zero PMMC meter, one is true rms meter and one is moving iron meter. What are the reading of these three meter respectively?
why constant voltage transformer should be start without load? and if started then what will happen?
Earth leakage relay basic knowledge principle
Type of motor stater detail and working detail
Define cut-off rate?
what would u consider to be the basic purchase order information you would need to proceed with a cable inspection assignment?
which one is more efficient, torq, power & ecnomy with the same frame size AC motor / DC motor?
why starting current is high and resistance is almost 0 during the starting of motor dc motor...?
Please tell me the formulaes while designing a substation for power Calculations in designing a 33 KV Substation?????
When are the directional relays used?
we have amp, voltage, kw, length detail then how to calculte copper & alluminium size of conductor of 3-phase induction motor
I have a small system with two motors that are running on 380 vac, 60 hz. These motors are expensive and I usally get them from Brazil. I am adding another motor to the system, but I want to purchase a 480 vac, 60 hz motor to use. It will be on a VFD that is rated fro 380 thru 480. Is this posible and will I have to use a larger motor and derate it?
Explain the experiment on ward leonard method of a speed control on a dc shunt motor with an suitable circuit diagram.
why does a dc machine has high efficiency while working as a generator than as a motor ..
What should be the percentage increase in length of the dead end clamp for bus bar conductor (Hawthorn) after hydraulic pressing and what should be the applied pressure?
