Answer Posted / faiyaz ahmad
Field bus is communication protocol which is used to communicate between the transmitter and controller like PLC and DCS Transmitting and receiving the signal through a Field bus protocol.
| Is This Answer Correct ? | 0 Yes | 0 No |
Post New Answer View All Answers
when the instrument tapping on pipe line is located below and transmitter is located above the tapping point for liquid service transmitter, what should we do, is there any additional drain valve is required??
What are different types of cable?
what different types of problems do occur while doing instrumentation commisioning and how to solve them? please explain in detail
any one can send me instrumentation previous interview papers? I prepare for MNC Company Interviews? my mail id- Rakesh.Golla@dodsaldxb.ae , and another mail rakesh.gvk@gmail.com
What is the reason PT speed not incresed in gas turbine?
how to measure oxygen which methods are using?
What is voltage regulator?
how can be calibrate flow indication transmitter (rosemount) it shows excess milli amps nearly about 24 ma on full scale, but its scale was set on 20ma on full scale..???how can be simiulate..???
why we take %i0.0 as input for twido plc
What is the minimum rating availalbe for weld neck orifice in market?
detail of mass flow meter pricipal
Why does a pressure gauge installed on reactor, doesn't have any vent line below to release the pressure? Is it any kind of designing mistake or it actually does not require any vent line? And if it does not require any vent line below it then how we are gonna release the pressure built inside the pressure gauge?
How we can check the 2 wire proxy switch? & how it is connected to DI MODULE OF PLC?
What is intrinsically safe system?
why we use cascade control and feed forward control in 3 element drum level control measurement of steam drum .what is cascade and feed forward control system ?give example .
