Why used in layer by layer charcoal and salt used in earth
pits.
- 11 Answers
- 68160 Views
- CESC, HP, I also Faced
- E-Mail Answers
Answer Posted / shashi thakur
charcoal is maitain the low resistance and high
conductivity.
salt is desolved in water the possitive ions abserved by
charcoal and released so the earth resistance maintain
properly.
| Is This Answer Correct ? | 4 Yes | 0 No |
Post New Answer View All Answers
Why in 6 KV XLPE cable termination kit used and why not in 380 V xlpe cable same is not used
What are the advantages of thermal power plant?
Can we test the alignment of End shield and stator of turbogenerator without rotor insertion? Also how to fix maintain the alignment at site installation?
HOW TO CHECK THE VECTOR GROUP OF A TRANSFORMER YD11?
what is under coal gassification?
what happen if drive input fail momentry at 48.5 HZ frequency?
why ht cable end termination don't have a gland?
What are the section criteria for cables. Now everywhere XLPE power cable is used or PVC is also used?.
How can we find the breaking capacity of a Load breaker switch (LBS) fed from 11 kv supply??ex:50KA, 26kA etc???detailed step vice answer pls.
what is the cause of voltage dipp or swell in the transmission lines?
How to calculate earth fault current for 6.6 KV , 50 HZ , 756 Amps , 3000 RPM , 0.8 PF generator
3- What is the target from Zero Impedance, Single Phase Imp., S/C Imp. and magnetic balance tests?
what do u understand from filter factor of reactor?
internally connection of photvoltic module
Why we find the sensitivity for the CT's to check?
