Interested to Buy Any Domain ? << Click Here >> for more details...
What is the lap length for tension members if you have 16 dia steel bar and a concrete fc=30.9 and steel grade60 fy=414 mpa
- 4 Answers
- 7880 Views
- L&T, I also Faced
- E-Mail Answers
Answer Posted / sajin
If it's a compressive member the lap length will be 50d. ie 80 cm and for tensile member it will be 24d. ie 38.4 cm
| Is This Answer Correct ? | 1 Yes | 0 No |
Post New Answer View All Answers
For The preparation of goverment examination Which book i will prefer and by which way i will do the preparation for exam.
for 16mm thick cement plastring 1:6 on 100 Sq.m.New brick work,the quantity of cement required is.
how to calcualate the amount of stone,cement,sand required for 1cum of 450mm thick ruble stond masonary with ratio1:5, please me an answer with dtailed step
In an aggregate blending plant, water is sprayed before blending is performed. If the fine content in aggregate is as high as 25 %, will not the fines form into lumps / balls and distribution will not be uniform ? Further, the fines will stick onto the interior of pug mill and its content will be low. The mixed material is stockpiled for weeks / months before use. Will it not be better that blending is done in dry condition, and water will be added only during compaction at site. Please forward your comments and suggestions.
What are the reasons for geotechnical site investigations in uganda?
Where is the worlds longest elevator and how long is it?
one steel fixers how much ton steel fabrication he will do same how much tone he will binding?
I used Etabs software to analyse a high-rise building. And I want to use templated UBC-codes inside to calculate the Seismic load. My question is: whether or not I have to control the seismic load by base shear load which is manual calculation? (just for more clarification: I can control this by input the scale factor into Eartquake definition in Etabs) I would highly appreciate your answer.
How to do rate analysis for concrete work including shuttering work?
Which purpose we use deck anchor in bridges?
Bernaullis theorem deals with the law of conservation of mass momentum energy none
What are the common ways of demolition?
How to marking the building
What is the cemnent ratio
How many pyramid in egypt?
