what is the use of vacuum balancing valve in CEP
- 4 Answers
- 29342 Views
- Apicore Pharmaceuticals, I also Faced
- E-Mail Answers
Answer Posted / swaroop
Vacuum balancing line is required in CEP suction to avoid cavitation and provide positive suction to CEP. As CEP takes suction from HOTWELL (which is also in vacuum), So there will be -ve pressure at suction. As it is well known that at less pressure boiling point of water is also less. Hence the condensate will try to vapourize at low pressure which will cause cavitation and pump will get damaged. Hence a vacuum balancing line ( A canister vent ) is provided at CEP suction to remove vapours which will directly go to condenser(which is in vacuum).
Thanks
| Is This Answer Correct ? | 69 Yes | 0 No |
Post New Answer View All Answers
I am requiering interview questions regarding Close Ferro Crome Furnaces
why we do not megger to motor under system is very high vaccum condition. and what is the tempreture of vaccum conditon
what is the difference between steel tube grade IS 1239&IS 1169
how can u increase the efficiency of a power plant without changing the effort?
what is the reson in a/c system that TPN TRIPPING
HOW LIGHTENING PROTECTION IS DONE ON ROOF OF SQUARE SHAPE AND HAVE PARTUCULARLY BIG SURFACE AREA.
Hai, iam renjith. my qtn about the calorex heat and cool pump. What is the reason of the above machine is trip on high pressure. r134a gas using in this system. 8 months old. model is calorex propac 90(3 phase). This system has 2 compressor. Both are starting on 13amps after that rise up to around 21 within 1 minute. After will be trip on high pressure. Showing 68 psi in suction side on standby mode. Can i have a solution without delay? Renjith renjithngm@gmail.com
what is procedure of measuring operating length of mechanical seal.(in case of centrifugel pump)
Is the hvac machines are designed 10% less than the electrical feeder value?
i am appearing for the interview of the company SANDVIK??so if u can send me some questions or suggestions on how to prepare,it would be of great help to me.u can send the above at ekjain@yahoo.co.in.thanking you.
What is a bearing?
What are the causes of steam turbine failure?
My parents green card holder and sister is citizen so... . I m applying for spring 2010 for F1 visa... how can i convince visa officers for visa?
Hi i am riyaz ahmed . i got rejected for first time and i nedd to apply for next time and can i apply in 1 or 2 week . and wt abt my sevies fee ? i should make a new once shill i go with the same and wt docement i should change can u plz help me out and my mail it is royalriyaz@gmail.com
which type of material is F125?
