Interested to Buy Any Domain ? << Click Here >> for more details...
How you take care of a motor from over loading and what are
the different overloading ratings of different motors?
- 4 Answers
- 10405 Views
- I also Faced
- E-Mail Answers
Answer Posted / aditya sharma
Overload relay will be use for overload protection
Different different rating of overload relay
| Is This Answer Correct ? | 0 Yes | 0 No |
Post New Answer View All Answers
How to test REF relay testing for LV panel as per Kahramaa standard?
We have Diesel generator of 200KW. fuel consumption is always same,even connected light load or full load. Is it right?
What is the lockout relay
What is steady state response?
with 3 phase board on a 63 amp rcd is it ok to have 6 electrical showers 2 on each phase and what problems could happen
Explain marx circuit.
A 3 phase transformer's (Y-Y) Y and B phase is (Y and B connection not broken) broken from neutral and R and Nutral connection is ok, what will be the relay tripping and why
a)In a 3-phase 4-wire circuit, a circuit breaker is selected to protect the circuit whose highest fault level is 6.6 MVA. Determine the required minimum breaking capacity in kA. (Note: Covert 3-phase power in terms of kA to find answer.) b)Using the below, determine the required minimum making capacity in kA as a “peak value”. Rate breaking capacity (Icn) ka: Icn<= 1.5 Factor = 1.41 1.5
Please clarify 1. Icw: rated short circuit working withstand capacity 2. Icu: Rated ultimate breaking capacity 3. Ics: Rated service short circut withstand capacity 4. other specification of ACB
bsec exam syllabus (mis)
what is subtransient , transient and steady stateac components
CALCULATE THE TOTAL VOLTAGE DROP AND SELECT THE CABLE SIZE IN MM-SQARE FOR A PANEL-262KW AT 110 METER FROM THE SOURCE SUPPLY , SUPPLY VOLTAGE 240/415
why we have to particulary use ACB for below ratings,even available of MCB,MCCB with that range ?
We have 250 KW x 2 motors, which are load from 25% to 100% varying load in every minute , so how can we compansate the power factor. pl give your opinions on the above subject.
can I improve the furnace power factor (10 mva transformer) by adding a capacitor bank before the transformer.Does system power factor vary a lot with the furnace PF?
