Answer Posted / vishal
50mm
Is This Answer Correct ? | 1 Yes | 0 No |
Post New Answer View All Answers
mix design procedure for 1:6 cement mortar
what is yield and tensile strength of steel, if steel has yeilding strength of 60 psi than how much its tensile strength?
Please tell me any one, how many quantity concrete paver block fixing perday ( 8hours) per mason??
How high should the water tank be to provide a 60 psi at base of this water tower?
What is the wall thickness of NP-3&NP-4 hume pipe as per I.S code
Trapezoidal section footing calculation of Volume & its Area
Which is the most prominent tower of world?
what is the formula to find the sttel (bar)length in beam having bent up at l/4 t 45 degree & 60 degree.
Can anyone tell me the sequence of the activities in a drawing room, kitchen & Toilet including civil work, finishing, electrical & plumbing fittings
Detection of a beam & a girder areββββ
what is pile and deam foundation
what is Bearing Capacity,How to determine it?
how we can find sieve #4 is 4.75mm?
As per Kandal suggestions, we have implemented rolling starts on 140 (+/- 5) degrees and we kept 3 rollars to complete the rolling before falling 125 degrees and the Aggregate AIV is below 22. But When the DBM bed is being rolled 3rd high viabration, (Before 1 plain & low ,2 high Viabrations), the aggregate is getting sharp edge agg. projections are damaged. As the literature is said that, the VG-30 Grade having better control the temp. susceptibility than Penetration grade. if so we could not get this problem at site. But we are facing on site. let me know.
How will drive weight formula for circular cylinder steel bar in kg/ m please step by step drive?