Interested to Buy Any Domain ? << Click Here >> for more details...
how to calculate the multiplying factor for energy meter
with CT ratio given
- 23 Answers
- 263434 Views
- Bhel, Dalmia Group, DIFC, Fedco, Hindustan Unilever Limited, Lupin, MahaDiscom, MAL Pakistan, Myunghwa Automotive, Panchshil Infrastructure, Regala, RVPN, VIPL, I also Faced
- E-Mail Answers
Answer Posted / raj bhoyar
M.F. = (CTRatio Of CT./CT Ratio of meter)*(PT ratio of PT / PT ratio of Meter)
if values feed otherwise null values will be treated as 1 not zero.
| Is This Answer Correct ? | 6 Yes | 1 No |
Post New Answer View All Answers
Is any generator is developed which is operated with out diesal or other expensive source?
I have a reading off 1.5ohms at my mem my main c/b is rated at 40/6 amps in a domestic house and i was told to change it to a b curve c/b is this ok
please suggest some good universities with low cost iam in totally full confusion so please help me my profile gre 283 and ielts 5.5
Why and when NGR panel required. Is it necessary to design a NGR panel for a 6.6kV Alternator paralleling with Grid????
how does high earth to neutral voltage affect electronic equipment?
UG cable sizes were specified in sqmm. But practically its not coming to mesure. What's the reason for that? And how they specify the size of the cable?
Transformer how to maintaince a check b check c check d check
What are gain margin and phase margin?
I WANT BHEL PREVIOUS QUESTION
how can we select the appropriate VCB ?
errection check list for transformer maintenance
how to find 5 kilo meter long under ground 33 kv cable fault location if IR VALUE shows 0.05 M ohm @5000 volt.and cable fault locator shows some time fault distance 3 kilo meter ,3.7 kilo meter and some time 1 kilo meter? now how to find the fault location that where is leakage. note--it is tested with 5000 kv megger and insulation resistance is 0.05 M ohm. and some time 0.03 M ohm comes.
Advantages/Disadvantages of earthing of neutral bus on MSB instead of separate neutral earthing for transformer/DG sets feeding to MSB
If more than rated DC voltage appears across trip coil of the breaker, what will happen? e.g. in 110V DC circuit system, if voltage across battery terminal showing 121 V
Is there any problem about which the drive (inverter) doesn't show/display the alarm and/or fault but instead of this , it doesn't work ? I want to know that could there be any kind of problem in the drive when the drive doesn't display the alarm and/or fault ?
