how to calculate stair case landing slab bottom shuttering
marking,angle of stair case?
top landing length-1250mm
treads length-2700mm(9X300mm)
rise length-1500mm(10X150mm
top landing level +1.5m lvl
bottom level-0.00m lvl
Answer Posted / chandra shekhar upadhyay
Calculation must be needed for stair case shuttring set up,from first landing bed if it is 1200mm - one trade (300x9)-2D(thicknes of slab)+remaning trade(300x8)
Is This Answer Correct ? | 0 Yes | 2 No |
Post New Answer View All Answers
1) write Short notes about Shellow & Deep well? 2) What is the full form of SPT & SMB? write short notes. 3) write short notes about efficiency of Riveted joint.
The properties of concrete HA-30 and how does it differ with M 30 (specify the important characteristics like workability,strength,mix design,slump test value)and what is the standard relating to it
How to calculate the force on a column of three story building. What should be the base concrete height?.
manhole height is 1500 mm and width of brickwork is 230 mm dia of manhole covering is 560 mm brick masonry 1:4 horizontal length is 1500 mm and plaster 12 mm thick on both side 1:3. how to estimate the quantity of brickwork with mortar cement and sand for manhole chamber.
how many types of survey and what are levelling instrument?
What is the cost of formwork for columns/beams/rcc walls also what is the cost of shuttering for roof slab at height of 25 feet
The building has 12 columns of 12x9 in 3 rows of 4 each in a plot of 50'x30', The central row is strengthened with 16mm twisted rods. The roof area is 1500 sft including balconies. calculate the load factor per sft. Also indicate the number of roofs the building can withstand.
What are the RISKS during the project construction?
What is the difference between undo & redo?
which steel is better for residential building tmt steel or hysd steel
PCC Road Min Grade M 30 for VR standard Mahatashtra load 30 KN. what should be thickness of pavement, width 4m what should be length of panel.
Define What does civil status mean?
how many monpower required for 1 sqm normal RCC structure ( includes finishes & MEP )
how to calculate quantity of cement,sand & aggregate for u.c.r / r.r masonry in cm 1:6
What are the important hardware systems used for cad?