If a normal magnetic type flow transmitter that can measure flow, temperature and show this parameters on field, is it possible by any means to get this (flow and temperature) parameters info. On dcs? And if yes then with HART, FO communication or any other communication system?
Answer Posted / rakesh bawankar
this type of FT called multivariable FT. it can measure tempreture also but we have to put temp element directly connected to FT then signal will go to sinal isolator and then it can give flow, pressure and temp at DCS. its simple HART protocol.
| Is This Answer Correct ? | 0 Yes | 0 No |
Post New Answer View All Answers
Is it ok, to use non-contact type Radar type LT, on a tank that is half circular from the bottom side? If yes the, isn't the waves gonna bent in other directions?
Explain bernoulli’s theorem. State its application.
what is the responsibility of an instrument commissioning supervisor
How can i copy program (parameter) from mm440 (V.F.D.) by using BOP?
what are the documents(Construction point of view for a process plant) submitted by contactor initially entering in to new site for client?
a flow transmitter [range-0-400mbar] connected in process line. please explain me how to calibrate the flow transmitter , & how to do static error
i have steam drum height 1000mm. and i want to placed the transmitter below the tap.how i calculate.
What is Cavitation in a control valve?
when placing a vent or drain hole on an orifice plate should you measure from the center of the bore up or down for the vent placement?
What are the interlocks we have to check during the start up of LP/HP compressor?
What is the use of temperature compensation?
what is the advantage of submersible level transmitter compare to ultrasonic level transmitter?
What is the use of single seated valve?
What is Predictive Maintenance
What denotes the 5/8mm in the 3300XL 5/8mm proximitor probe?