Interested to Buy Any Domain ? << Click Here >> for more details...
In one plant id fan and fd fan are used for boiler. boiler is used to heat water after some days they install one tank to heat water by hot flue gases coming out from boiler and then hot flue gases are used to heat the air coming from fd fan before leaving out from chimney . but hot flue gases are not coming out from id fan what might be the reason?
- 3 Answers
- 4669 Views
- TATA, I also Faced
- E-Mail Answers
Answer Posted / dhankhandhar@ymail.com
before chimney there is RAPH (Roatery air pre heater).so flue gas will pass from half the part of RAPH, and other half part is passing air coming from FD fan.So heat exchanges flue gas to FD fan discharge air .After that RAPH discharge is going to ID fan suction,thats how we are getting low temperature flue gas from ID fan.
| Is This Answer Correct ? | 0 Yes | 1 No |
Post New Answer View All Answers
How to calculate boiler capacity? I have 1 Autoclave, Which has to use for AAC block. Dimension for this Autoclave is - 13 Meter Length & 2.2 Meter Diameter.
What is LB-SR.
operation
how to differentiate between "ALL fuel lost" and "All Fuel Lost" in Boiler MFT condition?
What is surging in a centrifugal compressor ? How it occur's ? How is antisurging done ?
our 125 kva DG does not start in AUTO mode works normally in MANUAL mode please give me a solution.....
Why superheated are started before I'd and rd fan?
what is the basic use of power plant in equipment
Looking for Bently Nevada surplus 3300/52-01-00-00 Reverse Rotation Monitor , 4 pieces.
dear sir i have completed one year post diploma certificate in thermal power engineering from national power training institute durgapur ...plz suggest me for power sector job
can dp type level transmitter work in under vaccum condition
what is the meaning of SST300 V56A in SIEMENS turbine
What is difference between secondary Air & Tertiary Air and Their use.?
LAPT working in alternator / generator
DCS marshaling Cabinet Power supply can be replace during plant running time? Answer Yes it is possible. I am talking about the controller and cards power supply modules. They are always redundant and connected through diode so that if one power supply fails the other can take the charge immediately.so it is possible to replace one of them in running plant if the other one is healthy. MY question is how switching done.
