Interested to Buy Any Domain ? << Click Here >> for more details...
Why neutral has to switch on-off with phase in TN IT TT systems i.e neutral should be taken as fourth pole
- 1 Answers
- 2620 Views
- I also Faced
- E-Mail Answers
Answer Posted / k.prakashchandra
As a safety measure , the tr is completely isolated
| Is This Answer Correct ? | 1 Yes | 0 No |
Post New Answer View All Answers
how to calculate distance between busbar supporters for LT panel, what are the factors influencing in this design
What are the causes for the failures of sandwich type (Al) busducts?
sir please tel me how calucalte kwh if home taken load 30ams how maney kwh taken per day.and 3phase motor 5hp per hars how maney load teken and how mach kwh and forward me to electrical table for calicalte kwh and kvr and kvah
How can we connect additional batteries to three phase ups? What are parameters we have to check when connecting?
What are the symptoms of a bad PG card of a drive (inverter) esp. of Yaskawa Ac Drives (inverters) G7 ?
How to checked frequency drive output voltages?
In a carnot engine with an efficiency of 40%, the heat rejected to the sink at 27 C is 60 kJ, then the heat supplied in kJ to the engine by the sources is
1. If 8.35%Z means the percentage impedance of 132kV-line from power company, we will like to confirm its base capacity?
What is touch potential and step potential?
WHAT IS THE MEANING OF BALANCED / UNBALANCED IN STABILIZER TYPES.
How to arrange a hous hold earthing system to keep minimum earth resistance( below 7ohms).
hi guys please tell me the procedure for mesuring the coil resistance of 3ph induction motor?
can u give me a brief idea about power line carrier communication ??
WHAT IS MEANT BY SHEATH VOLTAGE IN 132Kv cable?
either water sensor or flow meter,how we observe the water level, f any other equipment are in market ?
