How ElCB tripping if Neutral touch with ground
- 4 Answers
- 13501 Views
- Sanmar, I also Faced
- E-Mail Answers
Answer Posted / thiyagarajan
How does ELCB WORKS?
If we are using a ELCB:
In fault condition or if the circuit is in open condition, current passes through the neutral.
We are connecting the ELCB from neutral to ground.
The fault or open circuit current in the neutral passes to ground and the equipment get protected from the severe shock.
BY,
THIYAGARAJAN.S
| Is This Answer Correct ? | 1 Yes | 0 No |
Post New Answer View All Answers
What are the different methodes for calculating the short circuit Current?
What is the efficiency during maximum power transfer?
advantages and disadvantages of inverse definite minimum time RELAY
Why delta star trformers are used for lighting loads?
Why use the vcb at high transmission system ? Why can’t use acb?
What are the uses of lead compensator?
if an insulated power and control cables of a running gas diesel gensets laid direct in an open trench i.e, trench bed is not rcc of a power house in which rain water, spillage water alwas exists and all power control cables remains submerged even when gas gensets of 480 kw each runningin on load. These power &control cables runs from power house to switchgear room through these trenches in which water remains most of the time. pl explain its merit & de-merit
what are the necessary basic electrical topics to learn for mechanical engineer to deal practical problems.
In case of HV test on medium voltage cables, BS is asking for 4 U0 where as IEC is asking for 3.5 U0. Can any one advise me how this 3.5 times or 4 times U0 is derived?
Please brief working principle & construction of permanent magnet AC Servo motor
Why do power lines not short out when they fall into water?
what is photo voltic cell,& what are the materials associated with that?and any spcifications like volts/cm etc?
How to measure power in 2 or 4 or n phase circuit? Please give me a formula.
The D.C. spark test is applicable to single conductor cable & assemblies of insulated single conductor cables without insulation shield,metallic sheath or metalic armor?
Define peak time.
