Interested to Buy Any Domain ? << Click Here >> for more details...
Answer Posted / abu maryam
scanning time:
In general: scanning time: it is the time taken to read all inputs then execute the program and apply on outputs.
In PLC: it is only 1 processor check the previous procedures so its scan time depend on the quantity of data and program.
In DCS: There are several processors each processor has its inputs and outputs and its private program so each processor in DCS has its private scan time applied on each loop.
| Is This Answer Correct ? | 0 Yes | 0 No |
Post New Answer View All Answers
what is the protection system in solar turbine compressor
why using negative supply for bentley nevada vibration system ?
model question paper of instrumentation for Jindal GET 2010.plz reply sudhanshukumar08@yahoo.com
How the warning lamp of a charging-system is activated ?
whatis range of marcury filled tempereture gague
tell me the field & lab calibration procedure step by step with diagram of pressure gauge, pressure switch, pressure transmitter, temperature switch, level switch, flow switch, flow transmitter, temperature transmitter, temperature indicator, flow indicator, level indicator, control valve, thermocouple, pressure indicator (digital & analogue),
What are de-saturators?
how do we commission inergen system?
how to calibrate 0- 150 psi presure gauge by dead weght tester
I was working on calibrating turbidity transmitters endress+hauser at effluent polishing plant.We calibrated using NTU buffers.What happened is that when we immersed the sensor, everytime we raise and lower the sensor gradually, the reading will vary.my question is that is there any specifications on what is the required distance from the bottom of the container with buffer to the face of the sensor?Is it ok to install the sensor in a medium which has turbulence specially if bubbles are present?
what is intrinscily safe system and where we use?
Why flow/pressure transmitter before control valve?
The company where I am working, their is rosemount 5400 series radar type level transmitter, it is meant to show level of filled tank, but along with the level it is showing temperature also, so my question is how a onon-contact type radar type level transmitter can show temperature even if it does not have any contact with the fluid?
Why mixer nd grinder Is example of constant torque load not variable torque load ???
how can leve transmetter calibate in feild .and also put cv and flow plz .....
