Column is a compression member then why we provide reinforcement on column?
- 1 Answers
- 3504 Views
- Simplex, Thermax, Vihaan Group, I also Faced
- E-Mail Answers
Answer Posted / george
To prevent buckling of the column
| Is This Answer Correct ? | 14 Yes | 0 No |
Post New Answer View All Answers
Design a built-up column carrying an axial load of 1200 KN. Its length is 8m and it is effectively held in position at both ends and restrained against rotation at one end. Assume yield stress of 250 mpa
Explain different types of rcc pipes.
What are the different approaches in designing the floors of the service reservoirs?
How much the quantity of Dry material of Crush for 1:2:4 Concrete, using pan 3/8'' down....
how much repeitation for conventional and maivan formwork?
Define What is the origin of name Railway Sleepers?
if i have to draw bending moment diagram of 4 way continous span then how to create it and how to find reaction?
Define What are the reasons for geotechnical site investigations in Uganda?
how many cement used in single story residential building per sqft
How can calculate the requirement of steel bars of rcc slab for 1100 sq ft?
Explain the Strength of brick?
I want to know the relevant IS codes of practice which deals with different testings of cement-sand mortar (nominal mix)that is being normally used for brick work or plaster work in the construction work.
In foundation design, while we do the base pressure check, we normally check if the attained pressure value is less than the GROSS BEARING CAPACITY of the soil which is the sum of net bearing capacity of soil and the overburden pressure. Actually, the overburden pressure acts against the net bearing capacity of the soil and I feel that we are actually increasing the bearing capacity value and doing the check. I feel that this is NOT right. Please clarify on this.
How many mortar required for Brickwork of 1 Cu.m works??
Dear sir, i want to NBCC & NTPC previous exam papers email Id : madhu_bingi@yahoo.co.in
