Interested to Buy Any Domain ? << Click Here >> for more details...
Answer Posted / muhammad abid ali shah
Line PT is used to measured the voltage and also used for voltage protection means that under voltage or over voltage and the bus PT is used for metering and measure the voltage of bus bar voltage.
| Is This Answer Correct ? | 4 Yes | 7 No |
Post New Answer View All Answers
Why is better to have a minimum ceiling voltage of 250% than 160%?
Iin ESP why positive is grounded ? why not negative ?
what happen if field of dc shunt motor opens? what is function of putting res. in parallel to one phase of 3 phase IM? the power supplied by 5A source in circuit is given by------Watt.
PLS SEND THE RRB CHENNAI MODEL QUESTION PAPER my email id is ganesan98655@rediffmail.com
i want use the cable size 16cx4 core aluminium usege watts 240x2000w this cable size is correct?
if two transformers are placed parallel & both have fault impedance of 50KA will it increase or decrease show example?
What are high pass filter and low pass filter? and What are the flowmeter ?
what are the problems that generally occur in power flows??
WHAT IS SITTING AMPS IN OVER-LOAD RELAY FOR 1PH OR 3PH MOTORS?IF ITS NAME PLATE GIVEN MAX AMPS 10AMPS?
why the making current is more than then the breaking current and if its true then its about a controling circuit or breaker power contact points
I need to connect a synchronous generator to the grid using automatic synchronization and two circuit breakers (one for synchronization, one for end connection to the grid), how to determinate the required diameter of the cables?
What are the advantages of a three-phase system over a single-phase system?
What is the principal of motor?
In a 3 phase 4-wire system. For a 3.5 core cable if all loads are single phase and balanced, what will be neutral current? will it be sum of all phase currents? Or it will be zero? And if loads are unbalanced what will be neutral current?
model question paper for supervisor trainee
