why breaker closing coil gets burnt if supply is continously provided to it.
- 1 Answers
- 2439 Views
- TATA, I also Faced
- E-Mail Answers
Answer Posted / k.prakashchandra
It is short time rated ,say about 5 seconds max .
| Is This Answer Correct ? | 1 Yes | 2 No |
Post New Answer View All Answers
what is the safety of voltage power transformer(2250KVA0
Graphs of measuring power and speed on dc motor
why would the rotor rotate at sub synchronous speed against the direction of rotating flux when d rotor of 3 phase IM is connected to 3 phase balanced supply and the stator windings are shortcircuited ??
Dg pf .71 i am improve pf 0.80 what capacitor connected in dg how?
describe the constructional features of an auto transformer and its principle operation
What are chief characteristics of state-space method and its techniques ?
What descriptive information does the NEC require to be marked on all conductors?
what are the principles of a booster converter?
In Electrical 'Single Line Diagram' cable nomenclature shows "2 X 1C X 630sq.mm to be provided for one incomer. The question is how many cable to be proved for one Incomer.
what is the pre charge circuit,what will be work which function it will be use plz tell me
If a shunt Dynamo has induced emf 100V and 0.4 ohm resistance and battery of accumulator of open circuit emf 110V and 0.5 Ohm resistance are in parallel what is common terminal potential difference?
Why earthing is necessary for any equipment?
1) What are your personal strength? 2) What are your personal areas of improvement? 3) What are your expectations from from a particular job? 4) what are your carrier objectives?
Define piezo-electric effect?
how to extend relay operating timing in 24V dc relay card (without using Timer )
