why the Steam Turbine(20MW)center line and gear box center line not in same elevation during coupling alignment ?
- 3 Answers
- 4053 Views
- Greenesol Power Systems, I also Faced
- E-Mail Answers
Answer Posted / amit singh
It will damage the shaft coupling and more even dangerous in running condition & JOP lifts the shaft not by weight u fool.
| Is This Answer Correct ? | 0 Yes | 2 No |
Post New Answer View All Answers
how to differentiate between "ALL fuel lost" and "All Fuel Lost" in Boiler MFT condition?
some one can tell me how residual type excitation is provided through transformers to an AC generator without any battery or PMG&excitor
What is difference between secondary Air & Tertiary Air and Their use.?
what is natural frequency of turbine shaft .
what does mean by kva rating
explain how the third harmonic content of the magnetising current affects transformer design
procedure of how to generate power in solar plant.
DCS marshaling Cabinet Power supply can be replace during plant running time? Answer Yes it is possible. I am talking about the controller and cards power supply modules. They are always redundant and connected through diode so that if one power supply fails the other can take the charge immediately.so it is possible to replace one of them in running plant if the other one is healthy. MY question is how switching done.
what is the trip circuit supervision in an electrical meaning?
our 125 kva DG does not start in AUTO mode works normally in MANUAL mode please give me a solution.....
What is surging in a centrifugal compressor ? How it occur's ? How is antisurging done ?
How to calculate power press toneage
Which will have more strain energy 1.Spring 2.Circular disc 3.Solid square plate.
what is the difference between compensated & normal drum level in boiler drum?
dear sir i have completed one year post diploma certificate in thermal power engineering from national power training institute durgapur ...plz suggest me for power sector job
