Why generator field rheostat is set to maximum position and
motor field rheostat is set to minimum?
Answer Posted / s.laxman
When the field rheostat is in minimum position more current will flow through field and hence more flux and therefore armature current is low and speed is less at the time of start
Is This Answer Correct ? | 6 Yes | 5 No |
Post New Answer View All Answers
Would you recommend to replace all oil filled cables with xlpe cable for hv transmission with the current technolgy for xlpe cable?
why should the primary of transformer be connected in delta in a heat run test?
what is the Earth Voltages in Power Plants, Sub-stations, Industries, Residential & Commercial Buildings.
how the speed of the gets motor regulated. does it draw the same current on the all speed level.
block diagram of 2 ups system connected in hot stand by mode?
please tell me how a surge protector work on a DC 48Volt.? please describe briefly.
wat is meant by PX class in ct?
When we use air circuit breaker, it has O/L protection ,time delay SC protection, Instataneous SC protection & ground fault protection. They all have some setting range. But what is the suitable/allowable setting for the above protection which will be safe for the equipment? For example-O/L protection setting have a range of (0.4,0.45,0.5,0.55,0.6,0.65,0.7,0.8,0.9,1.0)xIn Time delay SC protection have a range of (1.25,1.5,2,3,4,6,8,10,12)xIn Time delay setting is 0.02,0.1,0.2,0.3,0.4 Instataneous setting is fixed to 20xIn Gound fault setting is given 100A,300A,600A,900A,1200A This setting are for 2500A ACB. So what will be the basic allowable setting for the above protection? is there any formulae to calculate this<
what is the meaning of WYE and DELTA in Electric meter?
redundant connection in contactor?
we have provided 30 nos. relay contacts in panel.I want to know how do we do the numbering for the relay contacts as per any applicable standards
What is EHT tariff or Power factor Tariff ????
two phases with neutral supply can be taken in 3C X 10 sq.mm cable .
how to find ratio of CT & PT in 66/11kv 12 mva supply system ? explain with calculation.
What is the ratio of Booster transformer?