Interested to Buy Any Domain ? << Click Here >> for more details...
IF 5000amp current on LT 440V. then how much it will draw
amp on HT 11KV side
- 10 Answers
- 28083 Views
- I also Faced
- E-Mail Answers
Answer Posted / shamsuzzaman
HT side 22 Amp for 11Kv Line , LT side ( 11 Kv/415 Volts ) how mouch ampere of ?
| Is This Answer Correct ? | 5 Yes | 2 No |
Post New Answer View All Answers
how can we change the phase angle b/w two phase?
what is a speed of rotor when we give supply to stator of 50hz and as well as rotor of 60hz of an induction motor?????
1)what is the function of a frequency inverter? 2)If a few frequency inverter are connected onto a device network,what are the two setting that will ensure the frequency inverter work properly on the network. 3)whats is the name of the input sensor for weigher? 4)How to confirm that the load cellis faulty? 5)Describe briefly the steps to validate that the weigher is working properly? 6)Describe the procedure to validate the flowmeter accuracy? 7)Describe briefly the steps to validate that the tempreture sensor/transformer is working properly. 8)what is the adjustment that need to be done when you are calibrating the temperature transmitter ? 9)what are the safety measures to be taken before disconnecting motor for rewinding. 10)whats is the synchronous speed in rpm of typical 4pole 50hz motor? 11)whats is the formula for kw, ohm's law 12)if a 3phase motor is rated 3kw,415vac,what is it's rated ampere?
Why the output of OP-AMP is always less than Vcc?
how wecalculate breaking capcity of acb mcb mccb .explain with example
what happened when we supply a dc current in dc motor?? can it worked properly?
How to resolve if Diesel generator stop while running ?
What is the difference between rulling span and wind span of of an Over Head Transmission Line?
How to checked frequency drive output voltages?
How much weight an electrical engine can pull??
What are :- AC Distribution Board (Single & Double Front) DC Distribution Boards Distribution Board LT Breaker Panel.
Earth is a conductor or load?then ammeter connect to 3- phase supply,it shows the measurents or not?
what is different between relay and plc?
What is the effect on in Zone and out zone fault if Phase side CT is Vk/2<30 mA and Neutral side is CT is Vk/4<30 mA for Transformer REF protection
What are the electrical engineer roles and responsibilities in chemical plant?
