Interested to Buy Any Domain ? << Click Here >> for more details...
Answer Posted / mugil
Assuming 24 vdc I/O cards.
On a transistor output card Sourceing is PNP or Active High. This means that you connect the output to the + side of the load device and connect the other side to 0vdc. If the output Card is Sinking it is NPN or active low meaning that you would tie the + side of the device to 24vdc and the common would connect to the output card.
On input cards if the input card is a sourceing card you would use NPN sensors. The cards common connection would be to a +24vdc source and the device (sensor) would give a path to 0vdc. If the input card was sinking you would use PNP sensors. The sensor would be connected to the + 24vdc source and the output from the device would connect to the PLC input card which would have a common connection to 0vdc.
| Is This Answer Correct ? | 0 Yes | 1 No |
Post New Answer View All Answers
Can any body help to get Rsemulator 5000 free from internet if possible then give me any link or any help .
what is the diffrence between pressure safety valve & pressure relief valve....pls
what is cold loop? difference between hot and cold loop?
How to Calibrate Vortex Flow transmitter in field
What is the difference between mmwc and mmwg?
Calculate the maximum pressure drop that can be allowed to occur across a control valve, so that we can prevent cavitation / flashing from occurring. Use the following formula: Δ P allow = Km (P1 – PvapourA) where, Δ P allow - the maximum allowable differential pressure for sizing purposes, or terminal pressure drop; Km- the valve recovery coefficient from the manufacturer’s catalogue; P1 - absolute inlet fluid pressure; PvapourA - absolute fluid vapour pressure at the inlet temperature; Use Atmospheric pressure = 101.3 kPa, P1 = 1200 kPa(g), PvapourA = 4 kPa, KM = 0.72
What happen if I install my pressure transmitter below the elevation of pipe in natural gas service?
1.what is the power consumption of three element drum level control in sugar industries? 2.how to reduce that?
What are the interlocks we have to check during the start up of LP/HP compressor?
anybody having Qatar Petroleum questions for instrument Technician offshore ....please send me
how to calibrate corollaries (Mass flow meter)?
Can any one send me IOCL instrumentation question papers.. i dont know the pattern of the questions and what to prepare can any one help me on this .. my email id is anwarnishil@gmail.com
pls suggest suitable MOC of diaphragm for pressure measurement of UREA grade solution service fluid.
flow transmitter formula?
Do you have reference list?
