Answer Posted / rathn kumar

Consider a shaft, if its ok if u give value,and -value,(any one at a time) if it works in that way, then it is the bilateral tolerance;

If only one way the shaft going to be fitting, let it be in value case, and not in -value case , then it is the unilateral case. Is it the answer?I think so!

Why pistons are usually dished at top ?

1223

---

Tell us how do you discharge your duties in your duty post

5660

---

What is the color of the flame of the boiler running in good condition?

2040

---

What is coaxing ?

1254

---

tell me about a time when u had to many things to do and u were required opinion prioritized your talks.

1792

---

State newton’s law of convection.

1027

---

How oxygen can be removed from steel during melting? What are fully killed steels ?

1127

---

Is there a lower limit to the gland surface finish for static O-rings, gaseous system? surface finish table lists 0.41-0.81 micro-meters for static gaseous systems. What is the drawback of using a smoother surface finish lower than 0.41?

1838

---

Hello sir! I hav read the above discussions about PSU.I hav 72% aggregate in Mechanical bt i do had a back in 1 subject,so m i too eligible for PSU?

2155

---

A fan is handling hot air at 285 degC with flow of 411635 m3/hr, power consumed is 1165kW and efficiency is 66%. what will happen to flow, power and efficiency of the fan if a water spray system is introduced to reduce the air temperature up to 200 degC? (also please refer any document regarding this)

1878

---

How many lubricating holes are there in cylinder?

1957

---

What are bevel gears and what are its types?

1037

---

DIFFRENCE BETWEEN ISO AND TS

2255

---

List two effects of manganese in plain carbon steels?

939

---

Gegger is used in foundry for the purpose of____________

2123

---