Interested to Buy Any Domain ? << Click Here >> for more details...
What will happen if " not connecting the neutral point to
ground of diesel generator output (380 V)", also if someone
touched one phase without isolation from ground during the
A/M condition what will happen to him?
- 3 Answers
- 6796 Views
- I also Faced
- E-Mail Answers
Answer Posted / dhinesh
Due to the potential difference between the generator and earth the person will get shock.As the neutral is not grounded we don't have any option for protection.so the person who touch the phase is under risk of shock.
| Is This Answer Correct ? | 0 Yes | 0 No |
Post New Answer View All Answers
what is gas turbine intercooling ?
1. what is usage for power factor in industries?? 2.why we need to monitor power factor??
how can service sitting be setted for MCCB?Example for sittings IR (CURRENT RATING),IS(CURRENT STARTING)IO (current operating)?
what is the voltage regulation for unity and zero power factor?
DC transmission
Trafo ratio is 11kV/6.6kv,Vector group is YND11. What will be the effect if secondary is used for earthed system.
For overhead protection we use which transformer?
What is the Resposiblity of Electrical Utility Engineer
I have done my m.tech in electrical engg discipline. Can any one please suggest me how should I prepare for getting into phd in iit or nit.How should I prepare for getting into lecturership
diff b/w elcb and rccb
how to caculate cable size for diff types of loads? if anyone know the calculating procedure please tell me
what is inverter and converter
Hi everyone, I'm Lachuu, recently joined automation company as PLC Engineer. I have certain basic question, I request all big gurus and seniors to answer these question. Because this will be very helpful to me as well starters like me. How to design a control circuit (ex: pick & place - my current project) Yamaha robot PxYx series controller RCX222, using 6 cylinder double acting, plc keyence kv p16r 2 expansion unit for input and output each. How to select panel terminal mcb elcb powersupply. My main concern in some projects how to select dc power supply, mcb rcb(I came across dif bt b c d curves, but stil confusing, pls help me :-(. I would really appreciate all who are going respond to this question.
Draw a 230kv two-bus bar system showing the following. 1.Two generators (150MW) each connected through one 15.75/230KV transformers 2. 1 outgoing lines 3. Two 230/130 KV transformers 4. BUS PT's 5. CT
In TNC switch, is there any 1NO+1NC block ? and if we move over closing position, is ther any affect on trip position or vice versa?
