Interested to Buy Any Domain ? << Click Here >> for more details...
Answer Posted / venkatesh
Vacuum is created in condensor because in LPT turbine steam having less pressure after expansion so we need that steam to convert into water.So at 1 atm and 100 deg water will convert into steam.At lower temp we need to convert steam in to water so we used vacuum pump to create negative pressure.if we achived Ideally -1 vacuum then their is no loss of water but practically it is not possible max we can reach -0.9 vacuum.
concl:Vaccum is needed to convert low temp stm into water.
| Is This Answer Correct ? | 7 Yes | 6 No |
Post New Answer View All Answers
I Just want do EHS Certified Certification Distance Course From Govt approved,so can any body provide me details.
what will be happen if earth point is being used for as a neutral point for raw power , and same will be used for ups earthing
To prove the capacity of a 10MVA transforemr with 6.5% impedance by a short circuit test how much power is needed to inject an impedance voltage if we have to arrive for its rated current?
Give some example of fault limiting devices?
how to get bearing & winding temperature of an induction motor?
Hi,iam a diploma in electrical engineering.rtd from indian air force in apr 2007.prsently working in reliance next link as a network maintenance engineer since 2007,can i get a job in motherson sumi.
why 5kW motor becomes unbalance if its relay trip 1st time and its set value is 7.0 A
what is the excess air in furnace
can anybody send me syllabus of rrb section engg (electrical). and also send previous question pepar...
what is cascade speed control device?and how this device control the speed of motors?
what happen if drive input fail momentry at 48.5 HZ frequency?
I AM GOING TO ATTEND APTRANSCO ON 26TH OCT 08.PLEASE SEND ME ANY MATERIAL OR TYPE OF QUESTIONS OR EXP QUESTIONS.
The 3 phase 400 hp 440 volt slip ring induction motor do not take one phase amps why ? The motor is running good condition
the typical output of a solar cell is........
how to choose cable size with respect to load? how to convert cable size in mm2 to sq.mm?
