What is the permissible value of earth resistance!
- 11 Answers
- 34053 Views
- Torrent Power, I also Faced
- E-Mail Answers
Answer Posted / d m chudasama
it depends upon eath compositon. But shoud be normally less then 5 ohms.
| Is This Answer Correct ? | 1 Yes | 0 No |
Post New Answer View All Answers
IF 8255 CONTROL WORD IS 94H,Tell the chip port work mode ?
What happen if 200 KVAR capacitor connected to power continuesly?
What are the relays in ACB and VCB
Circuit diagram of tube light without starter using electrical choke
What is load boxes ?
why high speed tripping relay is used in protection circuit why not normal relay
in HT service 3ph 4 wire service Y-phase voltage shows zero . whether it is meter fault? or what be the reason ? if y-ph voltage zero ,can current is recorded? reasons for failure?
On a 6 KVA UPS we have to provide a DC MCB for Battery bank of 16 nos (12 V 42 AH). What Shall be the current rating of DC MCB ?
I want to ask that is there any relation between current denesity of copper and material purity. also is ther any standard which defines the standard current denesity of material.
what is effect of length of air gap on performance of dc motor and generator?
In our factory so many iron pillors are exists for supporting the shed/Hangar. If do more no of earthings at one piller instead of doing more earth pits in many locations and running earth strip around the hanger, I can save the money. Please suggest this method is acceptable as per Is specifications though the Earth resitance of the farthest piller is with in the limits as per IS specifications.
Electromagnetic torque developed by the motor is compared to shaft torque. A less B same C depends on motor design D more
why can the rotor of 3 phase slip ring induction motor not be a 2 phase rotor?
why zero sequence impedance measurement is not applicable for single phase GT
in our all power plant have connected in grid and grid voltage and plant voltage is same, but as per as electrical concept the power will transmit from high potential to low potential but here altough same,then how power transmit from power plant to grid.
