For 150 mtr cable run from DCS panel to transmitter (24 VDC with 4-20 ma output), need cable size. 1.5 sqmm is suitable?
Answer Posted / mugil
below 250 mtr you can use 1.5 sqmm and above 250 you should use 2.5 sqmm.Because if length is increasing voltage drop will increase that is the reason we are increasing cable the core size.
Is This Answer Correct ? | 10 Yes | 2 No |
Post New Answer View All Answers
Whether the DI, DOs shields can be connected with Analog Input Shield Earthpit?
NPN transistor, SCR, Zener diode, LED, Varactor diode, Vortex meter, RTD, Resistor, Crystal
In power plant to measure vibration of a turbine we install sensors. Before install this sensor we have to set gap voltage. What is meant by gap voltage and its use?
why orfice is not used for main steam flow calculation
If a warning lamp will operate with the ground circuit is bypassed with a jumper wire to ground, what should you check?
State some of balance principle’ advantages?
How to calibrate RC Feeder system in thermal power station?,If any instrument available to calibrate it,ple inform me. make:stock,
Programmable Logic control.
A flange is used for instrument connection for a system with a design temperature of 316C (600F) and a design pressure of 1000 kPa (145 psi). What is the class rating of the flange to be used for this application? Explain your answer
Isometric drawings are generated during _________________ phase of a project
you are on site,the plant trips,you are approached by operations,what do you do?
Identification of ss fittings, pilot valves, relief valve.
What is 3 element control system
Why grounding is necessary? Give example with diagram.
why use 50% lel methane gas concentration for gas detector calibration instead of 60% lel gas concentration whereas the hi alarm set at 60% lel.