Interested to Buy Any Domain ? << Click Here >> for more details...
my question is that....few days ago i had installed a three
phase motor starter for an electric saw.the motor will run
and make the hydraulic pressure which will be goes to
pressure cylender by up and down lever.two number of
limitswitches are also installed on cylinder for safety of
motor.now when the arm of cylinder reaches to the upper or
lower limit it will cut the motor's line.and motor will be
stop.now wana know that what will i do that motor runs
continue after the limitswitch cut it down but it shold not
be made any pressure.pls answer me in brief.
- 3 Answers
- 4802 Views
- I also Faced
- E-Mail Answers
Answer Posted / pvl
There should be some way to vent the excess pressure built by the motor. So first of all you should have a pressure gauge or sensor to read the pressure. Then you should have either a re-circulation line in the system or vent valve to channel the excessive pressure. When the hydraulic pressure reaches a set limit the re-circulation valve should open and channel the excessive pressure back to the tank/reservoir. In this way you can keep the motor constantly on without causing damage to system.
| Is This Answer Correct ? | 0 Yes | 0 No |
Post New Answer View All Answers
State and define ohm’s law?
what exactly commisioning work does in electrical site work... LT side?..
hai now i am working as a electrical design engineer in construction field can i get a job in oil and gass field or power plant project as a electrical design engineer?
How to calculate loses in transformer of 160 KVA ?
how can calculation ate Amps for cabel. Ex-for 1sqmm wire hou many amps we can draw
features of hbc fuses
what's the requirement of Dy11d0 connection of 3 phase transformer?what's use of it?
75 kw motor take 45 amp in no load delta in star 10 amp but in load it will take 160 amp but IR velue of winding above 500 at 1kw ph to earth and ph to ph. what problem it should be?
Atwhat condition reverse power relay will act?
pls someone send me sample question papers along with the key.thanks in advance
I have been using an 600VA with 0.6 p.f UPS with my desktop which has 450W power supply unit. Can anyone explain how can this happen . Because the output of the UPS is 360W (600*0.6) (<450W)
what purose of the double circuit transmission line phase of the line phase changed for circuit-1 for Circuit-2 R-Y-B B-Y-R
Which is the oldest hydropower plant in india?
how calculate the electrical load for industry and office
what is the minimum recommended leakage current of an earthed cable connected to the body or skid of an alternator
