What is the correct position of lapping splice of reinforcement steel bars in a beam at top & bottom of the beam?? what is the reason for this location?..what are the factors affecting lapping location in beam?
Answer Posted / muhammad asif
in case of continuous beams the top bars are lapped the center because the tension at the center at the top of the beam is almost zero and it is in compression while the bottom bars are lapped at the support because tension is at the top at support.
Is This Answer Correct ? | 14 Yes | 1 No |
Post New Answer View All Answers
if in column reinforcement lower dia connect to higher dia then from wher we want to start higher dia steel
Detection of a beam & a girder areββββ
HOW SOON CAN YOU TRAVEL DON TO ANY LOCATION POSTED U?
WHAT IS THE MAIN DIFFERENCE B/W HIGHWAYS AND MOTERWAYS?
what is the code provision for acceptance of fineness modulus range for fine aggregates in design mix
Give list of building construction equipment & explain about them in brief. How much is output of JCB, POCLAIN, Steel cutting & bending machine, material hoist, tower crane?
how much of quantity of material required for execution of one cubic meter of random rubble masonry in 1:3 cement mortar
What are the phases inspections are done by local authority while construction?
what is meant by shear center?????
In earth work 1300 cum soil how to calculate how many liters require in water
CAST EFFECTIVE WATER SUMP CONSTRUCTION DETAIL
door and window wood work calculations and different methods
usually hand broken stones are used for cement concrete 1:4:8 in foundation of single /two story houses with a view of economy in construction.what advantages it will give if you use machine crushed stone in place?
WHERE CAN I GET THE PREVIOUS QUESTION PAPERS OF APGENCO FOR THE THE POST OF Tr.ASSISTANT ENGINEER(CIVIL)
Which tests are performed on soil to decide the type of foundation to be provided.