What is the correct position of lapping splice of reinforcement steel bars in a beam at top & bottom of the beam?? what is the reason for this location?..what are the factors affecting lapping location in beam?
- 6 Answers
- 16534 Views
- SPCL, I also Faced
- E-Mail Answers
Answer Posted / saif rizvi
In simply supported beam lapping is not permissible.
In continuous beam
Top bar can be lap at the center or l/3
Bottom bar can be lap at l/3
This loction is as per bending moment
| Is This Answer Correct ? | 1 Yes | 2 No |
Post New Answer View All Answers
how much of the strength comes from post-production curing
what is education Cess.
Soil bearing capacity formula
What are the uses of alloys in daily life and how are alloys made?
1. For 10sq.m area(47 kg bitumen contain) of 45 mm thick bitumen mix layer..how much bitumen is required for 1600 sq.m and how much aggregate need for that ?? 2. And much tonnage of bitumen mix required for 10 sq.m area of 45 mm thick. Please give answer...
Consumption of Binding wire for fixing of cover block in vertical surface
PLS.......... ANY ONE CAN FORWARD ME PREVIOUS QUESTION PAPER hpcl civil engg
could u tell me how to used deform stell bar in reinforce concret?i wanna know the general using in the site!
how to calculate mivan shuttering matrial
There are two buildings one taller and one shorter whose time period will be grater and similarly the frequency ?
Why are steel plates inserted inside bearings in elastomeric bearings?
How to calculate the area in squarefeets ?How much area of sqft for this measurements?East 53.3ft West 54ft North 47.7ft South 51.1ft ?
While calculating the weight of the steel per running meter, the formula used is [(dxd)/162]. Why 162 is used in denominator & how it is derived?
types of piles detail,
Why joints are provided?
