Interested to Buy Any Domain ? << Click Here >> for more details...
Answer Posted / e.subhash
If a.C generator means
The following condition should be same before synchronizing the generator (whatever it may be it's size)
1) bus voltage and machine voltage
2) bus frequency and machine frequency
3) bus and machine phase sequence
4) phase angle
The following method is using for synchronizing.
1) dark lamp method
2) bright lamp method
3) synchroscope method
| Is This Answer Correct ? | 1 Yes | 0 No |
Post New Answer View All Answers
why three phase capacitor takes unbalanced current in capacitor bank?
why do motors burn out? I understand why adding parallel loads to a power source means more current moves through the circuit, and can destroy circuit elements by overheating. What about when you have a vaccuum cleaner intake flush against a floor, a room fan sitting directly against a wall, or a power drill trying to drill through something too hard?
Incoming line 11kv And transformer capacity is 2500kva. Consumption load is 1300A. Then fuse capacity is 11kv line.
what is W.T?specify the acceptable range?
A car's starter motor draws a current of 100 A at 12,0 V when starting the engine. The mechanical power required to turn the engine is 960 W. At what rate is energy from the battery converted to non-mechanical forms of energy?
In case of salient pole alternator when number of poles are 4 or more than 4 it helps the flux wave to be sinusoid as air gap length is increased from center to tip , but if the number of poles are 2 how does the flux wave is sinusoidal?
Does outdoor isolator loose connection cause short circuit current in that circuit? if yes then how ??
What is mathematical model of a control system?
what are the things that can cause a three phase motor to crawl?
what is effect of length of air gap on performance of dc motor and generator?
Draw transformer phasor diagram.(full load,no load)
sir plz send some previous year questions of jspl.
what is PID control in VFD drives?
What is the Basic Difference bitween Long Shunt Connection and Short Shunt Connection in DC Generator?
What willbe change in programming when we use 5/3 solenoid inplace of 5/2 in operating of a cylinder?
