Interested to Buy Any Domain ? << Click Here >> for more details...
Answer Posted / mughis
unintrupted power supply
| Is This Answer Correct ? | 0 Yes | 0 No |
Post New Answer View All Answers
EHV current carrying parts need to have smooth finish,then how can a 245kv GIS with emery finish can run so long?
DRAW ACIRCUIT DIAGRAM OF 100 KVA 415V/55-0-55V DELTA TO STAR TRANSFORMER
why the colour of insultor stack , petticoat is brown. Is it has some technical reason.
What Should be the value of Vector Surge angle at Tripping and how to calculate it?
why moisture formation found in XLPE Armoured cable outer sheath
What is control system?
How many devices can be connected in one zone of FACP
what is the difference between skin effect
What is the working mechanism of OLTC in Power Transformers????
What are the special cables required for explosion proof wiring?
1. A 380 / 220 V r.m.s. 3-phase 4-wire circuit carries loads of 8 + j8.1 ohm; 4 + j4.1 ohm; and 2 +j2.1 ohmin the three phases respectively. The length of the circuit is 100 m, and the resistivity of the phase conductors is 0.0005 Ω/m. The neutral conductor is of the same size as the phase conductors. a) Select a reference angle 0for the first phase. Then write down the three phase voltages in both polar format and complex number format. b) Make appropriate assumptions, and take temperature effects on resistance is insignificant. Calculate the currents in the three phases. (Note: Determine conductor resistance, and apply Kirchhoff’s Voltage Law) Based on the result, suggest a main switch rating for the circuit. c) Show your preferred direction of neutral current in a diagram, and then determine its value. (Note: Apply superposition principle, and Kirchhoff’s Current Law) Use its magnitude to show that in this circuit, the unbalanced load may increase the voltage drop in some of the phases. (Note: Also observe the common volt drip in neutral) State your assumptions, if there are any. d) Suddenly the neutral wire of the circuit is broken. Estimate the new currents in the first phase, i.e. Phase L1. State your assumptions, if there are any.
how to fit 3 HP crompton gear motor with conveyor with the use of staring delta starter or ordinary starter?
what are the different methods for the starting of a synchronous motor.
What is the loss of power of transformer 220kv/33kv,63/80mva of % imp12.05 at 80%load
What happen Grid EARTH plat got cut.
