Answer Posted / tasawar abbas suddle
When I sync. the two more than generator we must knowledge of the generator like as its frequency, phase seq, voltage magnitude & phase angel. and its capacity is also same.
if these generator capacity not same then when i start the generator will give the power to the system the other generator is small when big generator give the power to system and the other small generator will absorbed the power and it work like as motor.
and the second small generator will also absorbed power there is no benefit
| Is This Answer Correct ? | 0 Yes | 4 No |
Post New Answer View All Answers
why single CT used in DOL starter power circuit?
What is the dependency of stiffness on load angle??
What is frantic effect?
what is the id1 & id2 setting in differential protection relay of CSPC?
In India the supply voltage is 230 volt A.C. During the negative half cycle phase becomes neutral and neutral become phase? or what will happen during negative half cycle? how the electrons flow during positive and negative half cycle?
Is it acceptable of installing an earth pit in planters area where bare copper cable, earth rod and connection are susceptible to corrosion due to water?
how is the magnetic current test is different in delta-star and delta delta transformer.
what is the function of bearing in dc mchine" and where it is placed
In EHV transmission line a neutral grounding reactor is often placed at neutral point of shunt reactors. What is the recommended protection for this neutral grounding reactor? Should I use a fast closing switch to bypass neutral grounding reactor when this protection operates?
what is mean by PIR in circuitbreaker and give me detail of that?
Why water bubbles when D.C. Current is passed through it? Why not when A.C. Current is passed?
How to calculate flow of water delivered by pump when pressure & size of pipe line is given
what is the minimum (Common factor) insulatin resistance of the following a, 4mm sq wire b, cable from 50 mm sq to 800mm sq
various transmission tower like .,D tower ,K.C.O tower ,C.C.O tower,K.C.R tower ,C.C.R tower ,H.C.O tower in different tons.
What happen when change order of CT in GIS feeder?