What is the difference between ARC & SPARK?
- 4 Answers
- 37220 Views
- OPTCL, I also Faced
- E-Mail Answers
Answer Posted / thiru
Spark has discrete nature while arc has continuous nature.when there is loose connection at point of connection there will be sparking, and if you open high voltage isolator switch on onload,arc will be generated.
| Is This Answer Correct ? | 11 Yes | 3 No |
Post New Answer View All Answers
what are the specifications we must look at to select a relay for any capacity motor?
Hi.. I am a BE GRaduate in E&E. I have 8.5 Experience in Tendering & Estimation field. I have done SAP SD course few years back. But due to some reason i failed to get job in that field and continued my own field. Now I am thinking of changing into SAP seriously. How should i go ahead???
All the socket in a room become very hot, the Wall was also became very hot and the earth conductor also became live, what in your view might be the possible causes?
Difference between a pilot wire and a normal conductor?
why chock were used in old tubelights but are not newest tubelights?
How much of the total hydro power potential has been exploited so far in india?
WHAT IS ELECTRICAL MAINTAINTENCE ?
what is the difference between circular wdg & ractangular wdg?
Do u know any one? how to find out in motor rated amps? formula?
what is different between phase and netural
When and where resistance earthing is used ? How to calculate the time constant for earth fault
What are books to be referred for KPTCL exam?
Hi guys! Plz help me to answer the following questions. 1. What are the types of transmission line energy losses? 2. Why are the VLF are used some types of services? 3. What frequencies are used for reliable beyond the horizon terrestrial communication without repeaters? 4. To permit selection of 1 out 16 equi-probable, what is the number of bitis required? 5. What is the most common modulation used for telegraphy? 6. What is the multiplexing is used to increase the capacity of the optic fiber? Thanks
What is the percentage loss for aluminium wire for HT line more than 11KVa
how u select control transformer for a mccb panels or any panels?for expample we hav 440 volts maim supply and control volts is 230v?
