Interested to Buy Any Domain ? << Click Here >> for more details...
how can i design a APFCR panel?
please explain with example..
- 1 Answers
- 3276 Views
- Milestone, Reliance Jio, I also Faced
- E-Mail Answers
Answer Posted / himadri
For Designing the APFC we have to know the desire power factor of system and present power factor value.
After that we have to draw power triangle where kw value will be same. Form power triangle we can find the extra kVAR requirement to achieve the desire power factor.
That extra kVAR will be supply by capacitor bank. Then we have to fine out the capacitance value which will supply the extra kVAR.
| Is This Answer Correct ? | 2 Yes | 0 No |
Post New Answer View All Answers
how can i find ct ratio of meter by seeing name plate of meter and how it should be used in MF calculation if it shows only-/1???
1. A 380 / 220 V r.m.s. 3-phase 4-wire circuit carries loads of 8 + j8.1 ohm; 4 + j4.1 ohm; and 2 +j2.1 ohmin the three phases respectively. The length of the circuit is 100 m, and the resistivity of the phase conductors is 0.0005 Ω/m. The neutral conductor is of the same size as the phase conductors. a) Select a reference angle 0for the first phase. Then write down the three phase voltages in both polar format and complex number format. b) Make appropriate assumptions, and take temperature effects on resistance is insignificant. Calculate the currents in the three phases. (Note: Determine conductor resistance, and apply Kirchhoff’s Voltage Law) Based on the result, suggest a main switch rating for the circuit. c) Show your preferred direction of neutral current in a diagram, and then determine its value. (Note: Apply superposition principle, and Kirchhoff’s Current Law) Use its magnitude to show that in this circuit, the unbalanced load may increase the voltage drop in some of the phases. (Note: Also observe the common volt drip in neutral) State your assumptions, if there are any. d) Suddenly the neutral wire of the circuit is broken. Estimate the new currents in the first phase, i.e. Phase L1. State your assumptions, if there are any.
Differentiate between voltage and current feedback in amplifiers?
where was current transformer protection units used and why??
What is the best thing to protect the motor from running over full current. CT or O/L or pressure transducer at the given pressure rating
what will be happen if earth point is being used for as a neutral point for raw power , and same will be used for ups earthing
what is the common earth
How energy is generated in hydroelectric power plant?
What will be electrical cost per sqft for IT building (basebuild and fitout)and for residential township?
WHY IL=IPH IN STAR AND WHY IPH=IL/1.732 IN DELTA? WHAT IS REASON BEHIND IT?
what are the standard IR values should be of R-E, Y-E, B-E, R-Y, Y-B, B-R of VCB in closed condition and in open condition for 500KVA & 1000KVA transformers. and what is the acceptable range when tested by 5000V megger.
How to design inductive load for 3 phase 440v and maximum 5 amps for star or delta? Can we use a 15kW, 1450rpm motor for 15kW, 960rpm apllication?If yes.how......n.if thesame motor used what`s it`s sideeefect.
how can we say that stator magnetic field rotates with synchronous speed?can we derive?
How is the gain affected by the introduction of feedback in a control system.
Installation resistance for whole installation of 16 kva & 25 KVA DTRA a) Between each conductor b) between conductor to earth c) installation resistance for each apparatus, each conductor to earth d) earth resistance for the system of earthing
