how many cement bags required for one cum of brick work the brick size is 20x10x10.
- 1 Answers
- 3760 Views
- Casa Grande, I also Faced
- E-Mail Answers
Answer Posted / milind borkar
It is depends on what is a proportion of cement : sand .
Mortar proportion 1:4 or 1:6.
For example :- for 1:4 proportion 1.90 bags and for 1:6 proportion 1.25 bags
| Is This Answer Correct ? | 13 Yes | 0 No |
Post New Answer View All Answers
1. HOW MUCH CEMENT AND SAND REQUIRED TO PLASTER 100 SQM WALL. 2. HOW MUCH CEMENT AND SAND REQUIRED FOR SCREED WORK OF AREA 30 SQM
how to calculate the strength of rebound hammer test reading in building construction ?
1)Why we can use half brick in 4inch wall and 2)why not in 9+inch brick wall
what energized you to complete your course?
how do we design mix ratio?
significance of specific surface area of particles?
In an aggregate blending plant, water is sprayed before blending is performed. If the fine content in aggregate is as high as 25 %, will not the fines form into lumps / balls and distribution will not be uniform ? Further, the fines will stick onto the interior of pug mill and its content will be low. The mixed material is stockpiled for weeks / months before use. Will it not be better that blending is done in dry condition, and water will be added only during compaction at site. Please forward your comments and suggestions.
what is the design procedure for building
at which depth the construction of tunnel is economical from cost and engineering aspect.
Explain the water bound macadam roag
How to calculate density of 40 mm coarse aggregate, in mixing ration 1:1.5:3? Please explain calculation for density
You have 3 snd sample of different FM=0.21,FM=0.95,FM=2.90 which one is suitable for a)plastering on R.C.C b)plastering on masonary wall c)concreting column d)concreting of bored pile.also justify your answer.
Rate analysis of 150mm, 100mm, & 230mm thk BBM work
Define What is a kip?
what is the difference between natural draught cooling tower and induced draught cooling tower
