What should be the voltage between Neutral and Ground in
secondary side of the step down transformer (230 V to 110 V)
with no load condition?
- 4 Answers
- 6411 Views
- I also Faced
- E-Mail Answers
Answer Posted / rams dharavath
The voltage between neutral and ground should be less than 5volts
| Is This Answer Correct ? | 0 Yes | 0 No |
Post New Answer View All Answers
700KW 6.6KV slip ring induction motor to use VFD to control the speed
how can we change the phase angle b/w two phase?
Why the unit sizes of hydro generating machines are not standardized as in case of thermal powerplants?
Dyn1 transformer vector group testing how to do
UG cable sizes were specified in sqmm. But practically its not coming to mesure. What's the reason for that? And how they specify the size of the cable?
what is the formula for efficiency of francis turbine and generator for hydropower? what is best way to select francis turbine and generator?
In a carnot engine with an efficiency of 40%, the heat rejected to the sink at 27 C is 60 kJ, then the heat supplied in kJ to the engine by the sources is
we need a ntpc previous papers
how cables go in and come out for distribution from the feeder pillar box?
why you don not show protection and type of isolation in key single line diagram?
What is the relation between frequency and motor rpm?
What are the basic properties of signal flow graph?
what is power factor ? how we can calculate the low power factor and amount of capacitor for improve that low factor ?
how to prepare the technical test
After doubling voltage from solar cells & use step down voltage transformer can we get high current output with low voltage.
