Interested to Buy Any Domain ? << Click Here >> for more details...
Calculate the cooling duty, H required to condense and cool acetone from 100 degree Celsius to 25 degree Celsius at atmospheric pressure. The heat of vaporization for acetone at its normal boiling point is 30.2 kJ / mol. The boiling point of acetone at atmospheric pressure is 56 degree Celsius. The flowrate of acetone through the condenser is 100 mol / s = N. Value of sensible heat needed to increase the temperature of acetone in liquid form from 25 to 56 degree Celsius is 4.06 kJ / mol. Value of sensible heat needed to increase the temperature of acetone in vapor form from 56 to 100 degree Celsius is 3.82 kJ / mol. Unit of H is kJ / s.
- 1 Answers
- 4683 Views
- I also Faced
- E-Mail Answers
Answer Posted / kang chuen tat (malaysia - pen
Answer 13 : In the same state, total heat changes in heating = total heat changes in cooling for acetone. H = N ( total heat of sensible + heat of vaporization) = 100 (mol / s) [ (30.2) + (4.06 + 3.82) ] (kJ / mol) = 3808 kJ / s. The answer is given by Kang Chuen Tat; PO Box 6263, Dandenong, Victoria VIC 3175, Australia; SMS +61405421706; chuentat@hotmail.com; http://kangchuentat.wordpress.com.
| Is This Answer Correct ? | 0 Yes | 0 No |
Post New Answer View All Answers
how does the properties of an element changes by increasing protons and electrons?
How to caliculate the boil up rate, dia and height in both packed and tray distillation columns and any referance books for the design.
based on percentage problems
hi sir/madam i need placement paper of last years of DRDO in chemical sream...... send me the question paper as soon as possible on my email address praveen.zone@gmail.com
Name some common problems associated with dilute phase pneumatic conveying?
What is the ignititon temprecher of Diesel,Petrol&Carosion oil.
What is a common failure mechanism for above ground atmospheric storage tanks?
whats the allowed tolerance of pipe to pipe butt joint mismatching
How do you design a vapor-liquid separator or a flash drum?
can you explain about the design calculations and procedure of boiler
What is a good source of equations for calculating discharge flowrates from accidental releases?
Explain how can you estimate a gas flow based on two pressure measurements?
What is the best way to handle bend or turns in slurry piping systems?
How can you prevent bridging in a dilute phase pneumatic conveying system?
Is it ever advantageous to use shells in series even though it may not be necessary?
