Interested to Buy Any Domain ? << Click Here >> for more details...
what is hot loop check and cold loop check.
- 3 Answers
- 11108 Views
- Bapco Bahrain Petroleum Company, I also Faced
- E-Mail Answers
Answer Posted / krishnan kumar sharma
Hot loop cheak on point stabilise the instrument in field and the cold loop cheak from the junction box to DCS /PLC .
| Is This Answer Correct ? | 0 Yes | 0 No |
Post New Answer View All Answers
Explain the mechanism behind the turbine meter.
How to calibrate the flow transmitter
is there any digitel grevity meter availaible in the market by which we can measure specific gravity of a battery?
A PLC is programmed to drive three motors A, B and C as follows : After running motor A for an hour, motor B should get ON and motor A should get OFF. And after running motor B for an hour, motor C should get ON and motor B should get OFF. And after running motor C for an hour, motor A should get ON and motor C should get OFF. (That is, a cyclic repetition with time period one hour) Now, the second condition is: If any motor gone faulty and is tripped, the consecutive motor should get ON and the faulty (tripped) motor should be eliminated from cyclic repetition. The remaining two motors should bear the cyclic repetition of one hour each. (For healthy motor take logic as high and for tripped motor take logic as low) Now, the third condition is: When motor A load(Amps) exceeds 60% of its rated load, motor B should get ON in parallel to motor A. And when both motors A & B are running in parallel, and if their load exceeds 60% of their rated load, motor C should also start in parallel to A & B. [Here the cyclic repetition is eliminated, until their loads become normal(40%)] [Take logic high(1) for load at 60% and logic low(0) for load at 40%] Now draw a flow chart or a ladder diagram to fulfill the above condition.
What is feed factor and its Importance in cement industry? How we can solve feed factor?.
any body please send me the old question papers of ongc test.
If relative y axis vibration sensor is by passed, and relative x axis and absolute sensor is left working. how much monitoring i would have risked?
I want to buy a seal kit of a pneumatic power cylinder.But I don't know it's specification.So please help me to know its specification.
we want to control pump in let pressure and tank (for exp) our inlet line if water cam and pump will on and when our tank will full pump will off also if our inlet pressure low pump will off even tank not full.this pump i want to uses on our water supply line.
i have used level transmitter in starch cooking preparation tank. tank total height 2mtr.sometime LT display shows some error value when tank is fully empty and diaphragm side i already checked okay no problem in diaphragm area. field cable checked 24volt and mA shows correct value while tank empty mA is 4mA. 4mA i needed that 0% but display showing 10% or 15% percentage values are varying continously please give any good solution for me.....
A valve in series with an orifice plate (DP transmitter), is aligned for constant pressure in the pipeline, if there is an error dx, How to align it in process.
What is defferent betwen ESP &PCP PUMP .HOW IT IS WORK?
please tell no. & add. of consultancy who recruit me in power plant as instrumen engg. present i m working in power plant as ass.t instrument engg. thanku mahesh 09226562826
what are the documents(Construction point of view for a process plant) submitted by contactor initially entering in to new site for client?
few questions on RS 232,1 question on relationship of impedance and turns ratio, many questions on flowmeters
